30
LSQT1146
Setup
A few moments after the ACCESS/PC lamp
blinks, the cover of the disc compartment will
open slightly.
3 Open the cover of the disc
compartment by hand and insert/
remove the disc.
∫ Inserting disc
Fit the disc onto the spindle in the center and
then push the disc down until it clicks into place.
A Recording/playback side
B Pickup lens
∫ Removing disc
While pressing down on the spindle, grasp the
edge of the disc and gently lift it out.
≥ Take care not to touch the recording/playback
sides of a disc when inserting or removing it.
4 Push the section marked
PUSH CLOSE on the cover of the
disc compartment to close the
cover.
≥ If you use a new DVD-RW, it is necessary to
format the disc. (l 22)
∫ Identifying recording/playback sides of
disc
Single sided disc:
The recording/playback side is opposite to the
labelled side.
Double sided disc:
The “SIDE A” recording/playback side is the side
opposite the side with the “SIDE A” mark. The
A
B
LSQT1146.book 30 ページ ２００６年１２月５日 火曜日 午前１０時４０分
To Next Page
Loading...
