Panasonic Viera TH-L42E5K - Channel Renaming and Auto Tuning; Manual Channel Tuning Procedures

Tuning and Editing Channels
33
●
To rename the channel name
Set characters (maximum 5 characters) Store
Edit channel name
Name
select
set
●
To use numeric buttons (English only)
(p. 72)
Note
●
If a VCR is connected only with the RF cable edit [VCR].
Set all channels automatically [Auto Tuning]
Automatically retune all channels received in the area.
1 Start Auto Tuning 2 Settings are made automatically
Auto Tuning
All tuning data will be erased
CH 32
1 120
Auto Tuning
Scan
Automatically retune all
channels received in the
area.
●
All the previous tuning settings are erased.
●
When the operation is completed, the channel at the lowest position will be displayed.
●
Search begins in the order from the lower channels to the higher channels.
●
If tuning has not been done completely [Manual Tuning] (see below)
Set TV channel manually [Manual Tuning]
[Fine Tuning]:
Use to make small adjustments to the tuning of an individual channel (affected by weather conditions, etc.).
[Manual Tuning]:
Set TV channel manually after Auto Tuning.
●
Set [Sound System] and [Colour System], and then perform this function. Normally set [Colour System] to [Auto].
●
If a VCR is connected only with the RF cable, select channel position [0].
5.5MHz
CH570
1 120
Manual Tuning
Fine Tuning
Manual Tuning
Sound System
Colour System
Store
Auto
1 Select the channel position 2 Select the channel
3 Search 4 Select [Store]
select
store
Auto Tuning using the buttons on the TV
For Auto Tuning, using the buttons on the TV (p. 10)
1 Press the F button repeatedly until [Auto Tuning] appears
●
To return to TV
●
Control panel OSD appears
when pressing the control
panel button.
2 Access [Auto Tuning]
3 Start [Auto Tuning]
TH-L32_42_47E5KMT_EN.indd 33TH-L32_42_47E5KMT_EN.indd 33 3/19/2012 1:45:15 PM3/19/2012 1:45:15 PM