5
39-inch model
42-inch model
50-inch model
Assembly screw
(4)
M5 × 15
Assembly screw
(4)
M4 × 12
Bracket
Base
■ Assembling the pedestal
1
3
A
C
D
2
B
Secure the base as shown to prevent the
TV from falling over.
Commercially available screw
(not supplied)
Diameter: 3 mm
Length: 25 - 30 mm
●
The place where the base is secured
should be thick enough and made of
hard material.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV.
1 Remove the assembly screws
.
2 Pull out the pedestal from the TV.
3 Remove the assembly screws from the bracket.
Connections
●
External equipment and cables shown are not supplied with this TV.
●
Ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.
●
Check the type of terminals and cable plugs are correct when connecting.
●
Always use a fully wired SCART or HDMI cable.
●
Keep the TV away from electronic equipment (video equipment, etc.) or equipment with an infrared sensor.
Otherwise, distortion of image / sound may occur or operation of other equipment may be interfered.
●
Also read the manual of the equipment being connected.
Terminals
7
8
9
4
6
5
2
1
3
1
CI slot (p. 7)
2
Headphone jack (p. 7)
3
USB port
4
HDMI1 - 2 (p. 6, 7)
5
Terrestrial terminal (p. 6)
6
AV1 (SCART) (p. 6)
7
AV2 (COMPONENT / VIDEO)
(p. 7)
8
DIGITAL AUDIO
9
ETHERNET
To Next Page
Loading...
