Why does my Panasonic WH-UD07JE5 outdoor unit not operate?
The outdoor unit of your Panasonic Heat Pump may not operate due to the protection control of the system when the outdoor temperature is outside of the operating range.
Why does steam come out of my Panasonic Heat Pump in heating mode?
The steam coming out of the outdoor unit of your Panasonic Heat Pump in heating mode is caused by the defrost operation in the heat exchanger.
Why does my Panasonic WH-UD07JE5 Heat Pump make a water flowing sound?
The water flowing sound you hear during operation of your Panasonic Heat Pump is due to the refrigerant flowing inside the unit.
Why is COOL mode unavailable on my Panasonic Heat Pump?
The COOL mode may be unavailable on your Panasonic Heat Pump because the system has locked to operate in HEAT mode only.
Why is my Panasonic WH-UD07JE5 Heat Pump making a loud refrigerant noise?
The loud refrigerant noise that continues for several minutes in your Panasonic Heat Pump is caused by protection control during de-ice operation when the outdoor ambient temperature is lower than -10 °C.
Why does my Panasonic WH-UD07JE5 start automatically without the timer being set?
If your Panasonic Heat Pump starts operating automatically even when the timer isn't set, check if the sterilization timer has been activated.
Why does my Panasonic Water Heater make a loud refrigerant noise for several minutes?
The loud refrigerant noise is caused by protection control during deice operation when the outdoor ambient temperature is lower than -10 °C.
Why is my Panasonic Water Heater outdoor unit not operating?
The outdoor unit isn't operating due to the system's protection control when the outdoor temperature is outside of the operating range.
Why is the backup heater automatically turned ON in my Panasonic Water Heater when it is disabled?
The backup heater turns on automatically due to the protection control of the indoor unit heat exchanger.
Why is my Panasonic Water Heater system operation switching off?
The system operation switches off because of the protection control. When the water inlet temperature is lower than 10 °C, the compressor stops and the backup heater power turns on.
Provides warnings for indoor/outdoor units and explains safety instruction symbols.
Discusses electrical safety, grounding, and power cord precautions.
Specific cautions for indoor/outdoor units and the remote controller.
Highlights hazards of R32 refrigerant and installation precautions.
Covers safety related to refrigerant circuits and requirements for trained personnel.
Safety guidelines for installation space, pipework, and servicing personnel.
Safety procedures for work, refrigerant leak detection, and fire extinguisher use.
Ensures safety by controlling ignition sources, ventilation, and equipment checks.
Safety measures for checking electrical devices and repairing sealed components.
Details safety for intrinsic component repair, cabling, and leak detection methods.
Safe procedures for refrigerant removal, evacuation, and charging.
To Next Page
General