20
Fig. 5-5
8
Select the KNOB TEST Item by either UP or DOWN
Cursor.
8
Execute the KNOB TEST Item by pressing the Enter Key.
8
When executing, the Self Check will start for the Knobs.
First select the Q Adjusting Knob of the EQ Section
indicate to turn to right (reverse indication of the RIGHT).
8
Turn the Q Adjusting Knob to right, indicate to turn to the
left (reverse indication of LEFT).
8
Turn the Q Adjusting Knob to left, indicate to press this
Knob (reverse indication of KNOB).
If press the Enter Key instead of the Knob, this Knob will
be released reverse indication and next Knob becomes
reverse indication (Skip Function).
8
Press the Q Adjusting Knob, indicate to next Knob and
check the same manner as above.
8
The Jog Dial do not have press function.
8
The Self Check will be end after check of the Jog Dial.
5.15. LCD Test (LCD TEST)
8
Referring to Fig. 5-5, select the LCD TEST Item by either
UP or DOWN Cursor.
8
Execute the LCD TEST Item by pressing the Enter Key.
8
When executing, all face of the LCD is turn on (White
Indication) and off (Blue Indication) repeatedly by three
seconds.
8
Press the Enter Key to finish this Self Check Item.
5.16. Memory Initialize (MEMORY INITIALIZE)
8
Referring to Fig. 5-5, select the MEMORY INITIALIZE
Item by either UP or DOWN Cursor.
8
Execute the MEMORY INITIALIZE Item by pressing the
Enter Key.
8
When executing, all contents of the Memories such as the
Current, Scene, Library, Automation and. etc. have been
cleared and return to the initial contents which set in the
factory.
3.17. Execution of Upgrade Function (PROG-
RAM UPGRADE)
8
Referring to Fig. 5-5, select the PROGRAM UPGRADE
Item by either UP or DOWN Cursor.
8
Execute the PROGRAM UPGRADE Item by pressing the
Enter Key and all loaded programs in the ROM is deleted.
Note: All Programs loaded in the ROM IC have
been deleted if the Program Upgrade
Function is executed.
Must be need careful caution for execution
this function.
5.18. Fader Calibration Test (FADER CALIB-
RATION TEST)
8
Move the Cursor to most bottom position by either UP or
DOWN Cursor Key.
8
Select the Diagnostic Item (DIAG6) by either LEFT or
RIGHT Cursor Key.
8
Press the Enter Key, the Diagnostic Menu 6 as shown in
Fig. 5-6 is displayed.
Fig. 5-6
8
Select the FADER CALIBRATION Item by either UP or
DOWN Cursor.
8
Execute the FADER CALIBRATION Item by pressing the
Enter Key.
8
When executing, all Faders (21 pcs.) have been calibrated
and displayed measured value.
To Next Page
Loading...
