Panasonic WV-BM80 - Contrast Control; Video Input Connector; Video Output Connector; Camera Input Connectors

7.
8.
Contrast Control (CONTRAST)
Turn this control clockwise to increase the picture
contrast.
Video Input Connector (VIDEO IN)
This is an external video input connector for an external
or VTR playback picture.
When the external video signal is to be shown on the
video monitor, set the Input Selection Switch (2) to the
EXT position.
Video Output Connector (VIDEO OUT)
This connector is used to provide the video output
signals of the cameras to an additional monitor or video |
tape recorder.
10. Camera Input Connectors (CAMERA INPUT)
These connectors are used to connect the Mini CCTV
Camera WV-80.
These connectors supply the DC power and vertical
drive pulse to the cameras, and receive the video signal
from the cameras.
Note :
" Connect the camera. only after making sure that
the monitor is off. If the camera is connected while
the monitor is on, the camera will not function
due to activation of the protection circuit for
misconnection.
Cautlon :
@ When the WV-BL90A is used with WV-BMB80, do
not use the optional microphone unit WV-MC1.
The audio beat will be appeared on this monitor.
1. Power Cord