Panasonic WV-CP410

2. Installation of Auto Iris Lens Connector
When you use an auto iris lens other than listed on
pages 12, 13, 14 and 15, for example a video servo
ALC lens, install the lens connector (YFE4191J100)
coming with the camera as follows.
The following installation should be made by quali-
fied service personne! ro system installers.
(1) Cut off the iris control cable at the edge of lens
connector and then cut off the outer cable cover
as shown in the diagram.
Iris Control Cable Cut Off Lens Connector
Iris Control Cable 5/16" (Approximately 8mm)
| |
Bye
(2)
(3)
(4)
Cut off the inner cable covers of the iris control
cable as shown in the diagram.
1/4" (Approximately 6mm)
|
Put the heat shrinkable tubes or equivalent tubes
on the inner cables of the iris contro! cable.
Solder the inner cables of the iris control cable at
the pin-plug block accoaridng to the following pin
assignment and cover the heat shrinkable tubes or
equivalent tubes over the soldered area and heat
on the tubes to shrink them.
Pin. 1: Power source; +9V DC, 50mA Max.
Pin 2: Not used
Pin 3: Video signal: 1.3 Vp-p/40 kohms
Pin 4: Shield, ground
(Set the Lens Selection Switch (14) to the VIDEO
position)