Panasonic WV-CP414

(5) Both the connector cover and connector should
be positioned to interlock.
Connector
Cover
Heat
Shrinkable
Tubes
Connector
Note:
Cut off the rio on the connector, when the iris
contro! cable is too thick and the connector
cover and connector can not be interlocked.
-18-
3. Mounting the Lens
Caution:
(1)
(2)
(3)
Always set the Flange-back adjusting ring to fully
clockwise (C-mount side) by loosing one screw on
the ring before mounting the lens, otherwise the
inner glass and CCD image sensor could be
damaged by the lens.
Mount the lens by turning it clockwise onto’ the
lens mount of the camera.
Connect the lens cable to the Auto Iris Lens
Connector on the camera when an auto iris lens is
used.
Set the Lens Selection Switch (14) to the proper
position as follows.
DC: The mounted lens is one of the lenses listed
on pages 12, 13, 14 and 15 or one that
requires the DC conirol signal for auto iris
control.
VIDEO: The mounted lens requires video signal
for auto iris control.