Panasonic WV-CS650

- 20 -
■ Camera Setting
1. To display the Camera Setting Menu
• Move the cursor to CAMERA , and press the CAM (SET) key.
The camera setting menu is displayed.
*** SET UP MENU ***
PRESET 1 *
MAP
HOME POSITION 15
SELF RETURN 10MIN
AUTO MODE AUTO PAN
FLIP-A-CHIP ON
LOCAL/REMOTE LOCAL
CAMERA
Setup menu
** SET UP **
CAMERA ID OFF
ALC/MANUAL ALC
SHUTTER ---
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL ATW
MOTION DET OFF
AF MODE MANUAL
RET SPECIAL
Camera setting menu
Character editing menu
CAM1
Blinking
** SET UP **
CAMERA ID OFF
ALC/MANUAL ALC
SHUTTER ---
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL ATW
MOTION DET OFF
AF MODE MANUAL
RET SPECIAL
2. Camera Identification Setting (CAMERA ID)
1. Move the cursor to CAMERA ID, and select ON (to display the
camera identification) or OFF by using the joystick.
2. Follow the steps below to edit the camera ID characters:
2-1 Move the cursor to CAMERA ID and press the CAM (SET) key
to display the character editing menu. The character cursor
on the letter “0” and the editing cursor on the left of the
editing area start blinking.
2-2 Move the character cursor to the character you want to
change by using the joystick, and press the CAM (SET) key.
The selected character appears in the editing area. (The
blinking editing cursor moves to the right automatically at this
moment.)
2-3 Repeat the steps above until all characters are edited.
3. After editing the camera identification characters, follow the steps
below to set the position of the CAMERA ID on the monitor
screen.
3-1 Move the cursor to POSI, and press the CAM (SET) key to
display the ID position menu. The CAMERA ID starts blinking
and the ID position menu appears in the display.
3-2 Use the joystick to decide the position of the CAMERA ID on
the monitor screen. Press the MON (ESC) key to fix the
position, and return to the character editing menu.
Notes:
• When you want the pointer to move to a specific character in
the editing area, select a new character, and press the CAM
(SET) key. This function allows you to edit or correct a
specific character.
• When you want a blank space in the CAMERA ID, move the
character cursor to SPACE, and press the CAM (SET) key.
• When you want to erase all characters in the editing area,
move the cursor to RESET and press the CAM (SET) key.
CAMERA ID.--
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$ÄÜÖÆÑÅ
SPACE
---- POSI RET RESET
CAM1.......
↑
Blinking