3. Screw mounting: Screw one #10 wood screw into each screw-mount-hole until the base of
the stand is secured.
4. Tape mounting: ①Peel the paper liner off one side of each piece of tape and place the sticky
surface over each of the three rectangular tape holders. ②Peel the paper liner off the
exposed sides of each piece of tape and press the stand on a flat surface until it is secure.
Note: 1. More details refer to User Manual；2. For better readability, please print this document with laser printer. 3. Version:
MD22xx_QG_EN_V1.5.
To Previous Page
Loading...