Pandigital KTC Quick Start Guide

Quick Start Guide
1. Place the KTC monitor face
down on a so cloth with
the boom edge of the
monitor facing you along
the edge of the flat surface.
Tilt stand slightly to insert
Aach the Countertop Stand
®
the two tabs on the
stand assembly into
the slots on stand,
and then lower stand
so it lays flat against
the stand assembly.
2. Use a Phillips head
screwdriver to insert
three small screws
from boom
and hand ghten.
3. Turn the KTC upright
and remove the
protecve plasc sheet
from the front of the
monitor.
To mount on Wall or
Under Cabinet
Use the wall mount kit and
‘Flat Panel TV Mounng’s
Installaon and Assembly’
instrucons (separate doc).
Plug in and Power On KTC
1. Plug the power adapter into a wall outlet and then
into the power connector on the back of the KTC.
Wireless Wi-Fi Setup
for Internet Access
1
Remove the back baery cover and insert two AAA baeries (included) into the remote
control, matching the (+) and (-) symbols.
Install Baeries in Remote Control
2
3
4
Since you have not yet connected to the
TV source, you may see these messages
the first me you power ON the KTC.
To clear, press the SOURCE
buon on the remote control,
Use CH+ or CH- to highlight
DPF, and then press ENTER.
2. Press the POWER buon on the remote control or the power buon
on the KTC located in the middle of the speaker bar on the boom of
the KTC screen.
IMPORTANT:
‘Proceed with Auto Scan’ or
‘No Signal’ Messages
1
Insert the wireless Wi-Fi USB Adapter into the USB host port
on the le side of the KTC.
Connect the Wireless Wi-Fi USB Adapter
INPUT SOURCE
TV
AV
S-Video
Component
DPF
HDMI
PC
2
3
1. With the HOME screen displayed, press SETUP.
2. Use the arrows to highlight Network Setup, and then press ENTER.
3. Use the arrows to highlight Search for Network, and then press ENTER.
4. Select the desired wireless network, and then press ENTER.
5. Enter your wireles network Password; use the arrows to navigate the
virtual keyboard and press ENTER to select highlighted characters.
6. Select Done.
7. When your MAC and IP addresses appear on the screen, setup is
complete. Press EXIT unl you return to the HOME screen.
Set up Wireless Network on KTC
Establish accounts with Google Picasa
TM
and Windows Live FrameIt
Visit hp://picasaweb.google.com to set up an account, create folders, and upload your photos.
Visit hp://frameit.live.com to set up an account, create folders, and assign desired RSS feed content.
Connect to the Internet and Access Picasa and FrameIt
1. With the HOME screen displayed, use the arrows to highlight
INTERNET, and then press ENTER.
2. Refer to the INTERNET secon in the KTC User Guide for full
setup instrucons and usage for both Picasa and FrameIt.
The wireless network to which
you are connected should be
displayed at the boom of the
menu opons.

Pandigital KTC Specifications

General

Brand	Pandigital
Model	KTC
Category	Kitchen Entertainment Center
Language	English