EasyManua.ls Logo

Pando PLI-7360 - Page 217

Pando PLI-7360
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRESS DOWN
CLEANING THE SPRAY ARMS
CLEANING THE FILTER
ADD RINSE AID
Rusty spots at parts inside the dishwasher can be caused by incoming water
that sometimes takes rusty particles with it, caused by old water supply.
In case rusty spots appear at parts inside the machine please wipe away all
rust simply with cloth.
It is normal that the cutlery basket is usually in contact with dishes soiled by
coloured foods, such as tomato paste, it may be dyed with color , which is a
normal phenomenon.
In order to prevent the filters from being jammed by food
and soil particles and insure getting a good washing
effect, it is necessary that the filter system should be
cleaned at least once a week.
It is strongly recommended that : the filters
should be checked whether in correct position before using.
It is dangerous to open the door when washing,
because the hot water may scald you.
ADD DETERGENT
In order to avoid damage of the machine you have to use special detergent for dishwashers only.
The powder detergent always should be put into the detergent dispenser, never be put into the
dishwasher cabinet.
Please make sure the dispenser cover is closed before closing the dishwasher door.
WARNING!
NOTE:
1
2
If your dishwasher is equipped with visible heater ,
please do not place the cutlery basket above the heater.
The high temperature from the heater may damage
the cutlery basket.
PLACE THE CUTLERY BASKET
1 2 3
It is necessary to clean the spray arms regularly for hard
water chemicals will clog the spray arm jets and bearings.
To remove the lower spray arm, pull out the spray arm upward.
To remove the upper spray arm, hold the nut, rotate the arm
clockwise to remove it.
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.
Open
Open
1 2 3
OPEN
CLOSE
CLOSE
EN

Table of Contents

Related product manuals