12072021 6
PANTHER / PREDATOR / APPLICATOR ASSEMBLY PREVENTATIVE MAINTENANCE
6. Using even pressure on the motor, push the applicator drive motor back towards the applicator rack.
Note: The motor should not be overly tight against the applicator rack. If the motor and gear are meshed
too tightly, the applicator may short stroke.
7. Tighten the four (4) 1/4 - 20 x 1 1/4” mounting bolts to secure the motor in place.
8. Move the applicator rack up and down to ensure the motion is smooth and does not stall in any location.
Check the applicator rack for any broken or damaged teeth. Clean any debris or build up within the teeth.
9. Check the six (6) bearings on the applicator rack guide. Ensure all spin freely and are not broken. Replace
as necessary.
To Next Page
Loading...