Need help?Do you have a question about the Panther T-5 and is the answer not in the manual?
General| Brand | Panther |
|---|---|
| Model | T-5 |
| Category | Utility Vehicle |
| Language | English |
Threaded cable end must extend minimum 3 inches out of T-5 Unit before installation and be in tilt tube before tightening.
Use tightening nut or set-screw to secure T-5 to tilt tube, ensuring nut is tight against T-5.
Tighten cable end to solid rod, then back off 1/2 turn to prevent binding.
Use Seal Kit to keep moisture out of Tilt Tube; grease rod frequently to prevent binding.
Mount unit vertically, ensuring it does not obstruct full movement of the trolling motor.
Instructions for mounting the T-4/T-5 unit onto the motor's tilt tube, including rod length adjustment.
Attaching the ball stud to the kicker motor, including options for pre-drilled holes or drilling new ones.
Steps for connecting the drive rod to the motor's ball stud and the T-5 unit, including rod length measurement.
Guidelines for using the T-5 system, including disconnecting from ball stud when using main engine or trailering.
Warning against using the T-4/T-5 body as a step or resting place for feet.
Periodic checks of mounting nut and ball studs, greasing the unit, cleaning drive rod, and checking electrical connections.
Contact information for service and details on warranty coverage, exclusions, and claims process.
Details the one-year warranty, conditions for coverage, and disclaimers regarding incidental or consequential damages.
To Next Page