www.panthera-automotive.com
Hotline +49 163 33 66 55 6
Instructions for modifying the programs:
• Do not press any of the buttons during the acceleration process!
• The power pedal is programmed for the vehicle. All possible settings can be
used without any problems.
• If a program is changed by means of the respective key, it can nevertheless
occur sporadically to a fault message in the display or possibly cause an
emergency run, due to serial tolerances.
A fault message usually goes out after restarting the motor. For some manufacturers,
the fault message will not be switched on and off until 10 to 20 times.
The team at PANTHERA wishes you a lot of fun and a good trip!
To Previous Page
Loading...