Note: While you have the Kiln Sitter out, it is a
good idea to clean the back side of the Kiln Sitter
with compressed air.
Remove the 2
screws holding
theguideplateto
the front of the
Kiln Sitter.
Remove the guide plate.
Remove the 2 screws that hold the porcelain tube
bracket to the Kiln Sitter.
20
Prop the switch box on a chair or other ob-
ject. Do not strain the wires.
If your kiln is direct wired, you will also need to disconnect the electri
-
cal terminal box.
To Next Page
Loading...