paramondo CURVE - Page 43

www.paramondo.de
43
Anschluss und Inbetriebnahme • Connecon and start-up • Aansluing en inbedrijfstelling • Conexión y puesta en servicio • Connexion et
mise en service • Collegamento e messa in funzione • Podłączenie i uruchomienie • Elektrik bağlansının yapılması ve işleme alınması
L1
N
PE
M
M
Grid
230 V / 50 Hz
green/yellow brown
blue
L1 = Phase (brown)
N = Neutral (blue)
PE = Ground (green/yellow)
Connect the motor according to the connecon instrucons. To prevent that water penetrates the motor, the connecon cable should be
always laid downwards with a loop.
TIP: For the connecon of the power grid to the awning motor we advise to use the Hirschmann plug set. You can nd it in our shop under
the arcle number 10050625.
PE = (green/yellow)
1 = N (blue)
2 = (black/brown)
1
2
3
2 = L1 (brown)
PE = (green/yellow)
1 = N (blue)
1
2
3
Aer the connecon the motor vibrates briey and enters automacally for 10 seconds in learning mode. Since the enclosed radio remote
control is already programmed, it can control the awning immediately. Should this not be the case, you can program the remote control
according to the instrucons!
The end points are equally already set to suit the awning. Should you have to modify them, proceed as follows:
Connecon side motor Connecon side grid
EN
Adjusng screw for the end
point adjustment
red
white