Button 3
3/4
10.
VCF ON (cont.)
In VCF mode, the lter is normally "closed", just like turning
the cuto pot fully clockwise (full treble attenuation).
When you hit a note and the threshold LED comes on, it
will go through the attack portion of the envelope
- the lter will open up and hold it open until the signal
has dropped below the threshold (and the LED turns o
again) - then it will go through the release portion of the
envelope.
In VCF mode, the lter cuto knob now acts as a rate knob
insted. It now controls how fast it goes through the envelope.
From slow sweeps to fast wah'ish sounds.
To Next Page
Loading...