THRESHOLD
e threshold control sets the guitar signal trigger point.
is is used for both the lter envelope and the sustain
mode (see pages 10 and 17).
It needs to be adjusted so that the threshold LED (next to
the threshold pot) only lights up when you hit a note, and
turn o as soon as the note starts to decay.
Tip: Turn the pot fully clockwise (the LED will turn on) and
then turn it slowly counter-clockwise until the LED goes o.
Just around this point there's a small sweetspot that will
trigger the envelope/sustain mode) just the right way. Note
that the guitar output may be very low when playing on the
highest notes thus not triggering the threshold at all. is is
normal. Just nd a good compromise between sustain and
tracking.
Knobs
2/2
16.
To Next Page
Loading...