Page 65/71
8.6.2.3 Replacing the floor fixation compartment battery
A. Open the trapdoor of the floor fixation compartment.
B. Remove the protective cover from the battery located in the floor fixation compartment.
Battery protective cover
C. Disconnect the adapter strand (1) from the second battery strand (2).
D. Remove the battery (3) equipped with the adapter strand (1).
Disconnecting the strands
8.6.2.4 Installing the floor fixation compartment battery
A. Install the new and charged battery terminals positioned at the rear., equipped with an adapter strand,
orienting it so that the strand is on the left.
B. Connect the adapter strand of the second solar battery to the second solar battery strand located in the
floor fixation compartment.
C. Put the protective cover back on the battery by inserting the strands through the open side at the back
of the cover.
8.6.2.5 Final operations
A. Close the trapdoor of the floor fixation compartment.
B. Turn on the terminal.
C. Close the maintenance door.
D. Print a control ticket.
E. Check the battery voltage.
To Next Page