Adjusting the Pickup Height
DIMARZIO PICKUPS
Each DiMarzio humbucking pickup is secured to the body by two hex-head
screws. On the coil, closer to the bridge, the mounting screw is the screw
under the B string. On the coil, closer to the neck, the mounting screw is the
screw under the A string. Turn the screws clockwise to tighten and
counterclockwise to loosen.
To adjust pickup height, unscrew both pickup mounting screws. Raise or
lower your pickup to the desired position with your fingers. Retighten both
pickup mounting screws flush with top of pickup. Do not over tighten.
SEYMOUR DUNCAN PICKUPS
Each Seymour Duncan pickup is secured to the body by two slotted screws.
These mounting screws are located under the E strings on the outside coils.
Turn the screws clockwise to tighten and counterclockwise to loosen. To adjust
pickup height, unscrew both pickup mounting screws. Raise or lower your
pickup to the desired position with your fingers. Retighten both pickup
mounting screws flush with top of pickup. Do not over tighten pickup
mounting screws flush with top of pickup.
To Next Page
Loading...
Need help?
General
