STEP-STOP
BALANCE WHEEL
This two-position rotary switch is located between the height adjustment
screws, through a slot in the back cover
plate. Use the supplied step-stop/slide
wheel wrench to adjust the step-stop.
These two positions are:
The wheel is located inside the guitar and is accessed through a slot in the
back plate near the butt end of the guitar. Its job is to adjust the amount of
pressure the spring exerts on the bridge to fight the string tension.
IMPORTANT! Always tune your guitar in the FIXED or BEND DOWN
mode. Any problems that you may encounter with this vibrato system are
most likely caused by tuning the guitar when the bridge is not HOME.
To Next Page
Loading...
