5
The following mounting adaptations, method of assembly, and installation are for all MATRX Analgesia
Heads.
For Top Mounting Wall Mounted Units (see fig 3)
1. Remove the two 10-32 x ¼” screws from the rear, top of the head, and assemble the mounting
bracket to the rear top of the analgesia head by aligning the bracket with the bevel side to the
head and the 10-32 tapped holes in the head with the screw holes in the bracket.
2. Screw the two 10-32 x 1” screws (included) into the tapped holes through the clearance holes in
the bracket. Thread in screws until they are tight.
Mounting the 8" Wall Mount
To Next Page
Loading...