6
A. Wood Stud Mounting
Note: Mounting hardware is not supplied with the mount.
Using a minimum wood screw size of #12 x 2 ½” long and flat washer #12 x 5/8” minimum outside
diameter, mount the wall bracket directly to a wood wall stud through a maximum 5/8” dry-wall. Two
screws are required for each mounting (see fig 4).
B. Concrete Wall Mounting
Note: Mounting hardware is not supplied with the mount.
1. Drill hole in concrete wall as instructed by anchor manufacturer. Drive in anchor. Insert screw
through washer then wall bracket. Thread screw into anchor until tight. One screw required for
each mounting hole (see fig 5).
2. Refer to Figure 3. Slide stud on mounting bracket (attached to analgesia head) in bore located in
the end of the 8” arm.
3. Attach rubber goods as per Figure 1 and 2.
THE MOBILE STAND UNIT
To Next Page
Loading...