7
A. Thread hex nut onto mounting stud until at least ¾” of thread is exposed above nut on stud. (See
fig 11).
B. Thread stud into 5/8 - 18 tapped hole located on bottom of the outlet housing of the analgesia
head. Thread in until nut is reached. (See fig 11).
C. Using an adjustable wrench or the appropriate box wrench, firmly rotate the nut clockwise
(looking towards the bottom of the head) firmly until it stops against the MDM.
D. Slide the tapered nose of the pole mount assembly into the bore of spider stand until it comes to
a stop. (See fig 12).
E. Slide mounting stud through post spacer (if supplied) and into stud bore of pole mounting stud.
When the head is at the desired working height, rotate the stud lock clockwise until it locks the
stud. (See fig 12).
F. Connect rubber goods as per figures 1 and 2.
THE MOBILE STAND UNIT (cont.)
To Next Page
Loading...