Parking Facilities PF9700 - Mechanical Troubleshooting Guide

17
in
Parking and access control equipment manufactured in the UK
PF9700 Automated Hinge Gate
Gate arm keeps going up and down
Limit switch fault
check and reset limit switches
Gate creaking when moving
Check turn buckle
Oil or grease turn buckle
Gate motor not running
Loss of voltage
Check motor supply test 3 phases
Gate not opening or closeing
Drive shaft connections
Re-connect any drive shaft connections
Gate not opening or opening half way
Gearbox
Gears stripped due to overlading replace
Gate opens slowly and closes too fast
Lack of balance counter weight compensation
Fit counter weights
Gate not running at all
Door has been left open or switch not pushed in
Close the door and issues a signal to open or
close
Gate opens and will not close
Key switch is left in open position
Turn key switch to auto
Loop fault or loop detecting
Check if green light is on detector if so remove
object that it is detecting or replace loop
MECHANICAL ERRORS
CAUSE
CORRECTION
Troubleshooting Guide (Mechanical)
Notes