in
Parking and access control equipment manufactured in the UK
PF9700 Automated Hinge Gate
7
Please use the following instructions to operate
the Gate manually, the following
is assuming you have powered down the unit
and opened the cabinet door:
As stated at the beginning of this manual we
recommend a bi-annual service, but at a bare
minimum, it is imperative that you get a service done
once every 12 months. This is not a sales tactic in
disguise, there is a very serious health and safety
issue/risk associated with not complying to this. Also in
order for your Gate to keep complying with the
appropriate legislation.
Ÿ Before carrying out any maintenance to the installation,
disconnect the mains power supply.
Ÿ
Ÿ Make sure you have disconnected/Isolated the power
before attempting any work.
Ÿ
Ÿ A Maintenance Contract should be sought from a
specialist company after a maximum of 5000
manoeuvres or 1year from the install date.
Ÿ
Ÿ Occasionally clean the photocell optical components and
make sure they are free from dirt, water, rain, soil etc..
Batteries in photo cells may need to be changed
every 6 months or sooner dependant on use. Gate will
not work properly without photo cell function.
Ÿ
Ÿ Have a qualified technician (installer) check the correct
setting of the electric clutch.
Ÿ
Ÿ If the power supply cable is damaged, it must be
replaced by the manufacturer or its technical assistance
service, or else by a suitably qualified person, in order to
prevent any risk.
Ÿ
Ÿ When any operational malfunction is found, and not
resolved, disconnect the mains power supply and
request the assistance of a qualified technician
(installer). When automation is out of order, activate the
manual release to allow the opening and closing
operations to be carried out manually.
Ÿ Gearbox drive unit is “sealed” for life and requires no
further lubrication.
Manual Release Guide
To Next Page
Loading...
