Parks 12 - User Manual

OPERATING INSTRUCTIONS
AND PARTS LIST FOR
PARKS
12" THICKNESS PLANER
IMPORT ANT: This list is valuable. It will enable you
to secure prompt service on replacement parts and
avoid unnecessary
correspondence with our factory.
We suggest that you keep it filed away with other
valuable papers.
THE PARKS WOODWORKING MACHINE COMPANY
Manufacturer~ of Quality Woodworking Machines Since 1887
Cincinnati, Ohio 45223
Apr. 1, 1975

Summary

Motor and Pulley Recommendations

Lubrication

Adjustments

Prepare Table and Rolls

Place boards on each side and raise table until knives touch.

Set Feed Rolls and Pressure Bar

Lower feed rolls and pressure bar to touch boards for parallelism.

Adjust Feed Roll Height

Lower in-feed roll and out-feed roll by half turn of adjusting studs.

Pressure Bar Adjustment

Raise pressure bar slightly if board does not follow through.

Table Roll Height for Finish Work

Ensure table rolls are not more than 1/64" above the table.

Capacity

Resetting Planer Knives

Instructions For Ordering Parts

Parts List - Figure No. 2

Parts List - Figure No. 3

Parks 12 Specifications

General

Brand	Parks
Model	12
Category	Industrial Equipment
Language	English