GB MT
22
2. To remove the battery (19) from the de-
vice, press the release buttons (18) on
the battery and pull the battery out.
Charge level indicator
Press the button for the charge level indica-
tor (16).
The charge level of the batteries is indi-
cated by illumination of the corresponding
LED lights of the battery charge level indi-
cator (8, 17).
3 LEDs illuminated (red, orange and green):
Batteries charged
2 LEDs illuminated (red and orange):
Batteries partially charged
1 LED illuminated (red):
Batteries need to be charged.
Switching on/off
Switching on
1. Press the on/off switch (10).
The light (2) illuminates at level 1.
Switching off
1. Press the on/off switch (10).
The light (2) goes out.
2. Press the on/off switch again.
The device switches off completely.
Changing the light level
Change the light level by pressing the Level
button (11). The set level is indicated by
the light level indicator (9).
Level Lighting mode
1 Permanent - 1000 lm
2 Permanent - 5000 lm
Level Lighting mode
3 Permanent - 10,000 lm
/ Flashing
Pairing the LED oodlight
The pairing function works perfectly
up to a distance of 20 m (without
barriers).
Connecting the LED oodlight
1. Switch on the device.
2. Press the RF button (12).
The SYN indicator (13) ashes.
3. Repeat steps 1-2 for all LED oodlights
you want to connect.
4. Press and hold the RF button (12) for
approx. 5 seconds on the LED ood-
light that is to act as the master.
The SYN indicator (13) on this LED
oodlight ashes at a faster frequency.
5. Press the RF button (12) again to con-
rm the connection.
The SYN indicator (13) now lights up
permanently.
Disconnecting
1. Press and hold the Level button (11)
and RF button (12) simultaneously for
about 5 seconds.
Working instructions
Do not look into the light
source.
Swivelling the LED oodlight
(Fig. A)
The base (5) can be adjusted continuously.
The base cannot be xed.
To Next Page
Loading...
Need help?
General