Parkside Performance PRDSP 20-Li C2 User Manual

19GB
1. Insert the battery pack
[] into the rapid
battery charger[].
2. Connect the power cord with power
plug[] to a socket-outlet.
3. The charging control LEDs (green[]
and red[]) indicate the status of the
rapid battery charger[] and the battery
pack[]:
LEDs Status
Red LED lights up Battery pack charges
Green LED lights up Battery pack fully
charged
Green and red LED
flashing
Battery pack defective
Red LED flashing Battery pack too cold
or too warm
Green LED lights up
(without battery pack)
Charger ready
o When the battery pack[] is fully charged:
– Remove the battery pack[] from the
rapid battery charger[].
– Disconnect the power cord with power
plug[] from the socket-outlet.
 Inserting/removing the
battery pack
1. Open the battery compartment cover[5]
(Fig.I).
2. Inserting: Place the battery pack[] on
the guide track and push it back into the
product. The battery pack will audibly snap
in.
3. Removing: Press the release buttons[]
on the battery pack[] and pull it out.
4. Close the battery compartment cover[5].
 Checking the battery pack’s
charging level
Fig.C
o Press the button[] on the battery
pack[].
o The battery pack’s[] charging level is
indicated by the battery level indicator[]:
LEDs Status
Red‒Yellow‒Green Battery pack fully
charged
Red‒Yellow Battery pack half
charged
Red Battery pack needs to
be charged
 PARKSIDE app
 Connecting the product to
the PARKSIDE app
Activate/deactivate the Bluetooth
®
function on the battery
o Press and hold the button[] on the
battery pack[] for 3seconds to activate
the Bluetooth
®
function. The orange LED of
the charging level LEDs[] lights up. The
Bluetooth
®
function is enabled.
o Release the button[].
o Press and hold the button[] on
the battery pack[] for 10seconds to
deactivate the Bluetooth
®
function. The
orange LED of the charging level LEDs[]
goes off. The Bluetooth
®
function is
deactivated. In the PARKSIDE app the
product is shown as offline.
 Connecting the product to
the PARKSIDE app again
NOTE
u The product can only be connected
to the PARKSIDE app if the battery
pack[] is inserted in the product.

Parkside Performance PRDSP 20-Li C2 Specifications

General

Brand	Parkside Performance
Model	PRDSP 20-Li C2
Category	Paint Sprayer
Language	English