25GB
To avoid drifting, different parameters
should be taken into account when
spraying.
Examples:
– Nozzles
– Pressure
– Nozzle pipe length
– Wind speed
To reduce the risk of electrocution, never
work in the vicinity of live wires or power
cables.
Always clean the product before filling in a
different spray material (see“Cleaning and
care”).
Do not operate the product at temperatures
above +40°C in the shade or in direct
sunlight.
Start spraying
o Squeeze the trigger[] down to release
a stream of spray solution for spraying
consumer grade home and garden
chemicals.
Stop spraying
o Release the trigger[].
Continuous spraying without holding
down the trigger
(Fig.M)
1. Squeeze down the trigger
[].
2. Push the lock-on latch[] forward so it is in
lock position.
Unlocking the trigger from continuous
spraying
1. Squeeze the trigger
[] further down.
2. Fold back the lock-on latch[] under the
trigger[] (Fig.M).
NOTE
u During work breaks, do not leave the
product in the hot sun or near any heat
source.
u Overdosing may damage plants and the
environment.
Underdosing may result in unsuccessful
plant treatment.
Cleaning and care
m
WARNING!
u Always switch the product off, remove
the battery pack[] and let the product
cool down before performing inspection,
maintenance and cleaning work!
u Only perform repairs and maintenance
work according to these instructions!
All other works must be performed by a
qualified person!
m
WARNING! Risk of chemical
exposure!
u Always wear appropriate personal
protective equipment as instructed
by the chemical manufacturer when
using, preparing, handling, spraying, or
disposing of chemicals. This equipment
includes at least goggles, gloves,
respiratory protection and protective
clothing.
Maintenance
o Before and after each use, check the
product and accessories (e.g. nozzles)
for wear and damage. If you find any
damage (e.g. crack on the nozzle
accessories[], hole in the basket filter[]
or small filter[]), exchange them for new
ones. Observe the technical requirements
(see“Technical data”).
o Periodically check the shoulder strap[6] for
fraying. Replace the shoulder strap if it is
worn-out or frayed.
o You can order replacement nozzles, filters,
and other spare parts not listed (such
as the charger) via our service hotline
(see“Service”). Have the IAN number
available when you call the service hotline
to purchase spare parts.
To Next Page
Loading...
Need help?
General