26 GB
Repair
In case leakage is noted, it is likely that there
is a broken sealant ring near the source of
the leak. The sealant ring can wear over time,
which causes cracks and leakage. To replace
the sealant ring:
1. Switch off the product: Press the power
button[].
2. Remove the battery pack[].
3. Follow the instructions in the “Cleaning”
section to clean the parts near the leakage
area.
4. Disassemble the product at the source of
the leak. Inspect the sealant ring for any
signs of wear or cracks.
o If a sealant ring is broken or cracked,
replace it with a matching sealant ring.
Heed the outer diameter of the sealant ring.
o After you replaced any sealant ring, fill the
spray tank[3] with clean water. Carry out
a test run to check if the leakage has been
eliminated.
o Contact an authorised service centre or
a similarly qualified person to have the
product checked and repaired.
Cleaning
m
WARNING! Risk of chemical
exposure!
Always wear appropriate personal protection
equipment as instructed by chemical
manufacturer when using, preparing,
handling, spraying, or disposing of
chemicals. This equipment includes at least
goggles, gloves, respiratory protection and
protective clothing.
NOTE
u Do not use chemical, alkaline, abrasive
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces.
1. Prepare a container approved for
chemicals. Squeeze down the trigger
[]
to spray the residual spray material into
the container. Release the trigger once
the spray material has been completely
emptied.
2. Switch off the product: Press the power
button[].
3. Remove the battery pack[].
4. Unscrew the shut-off valve[] from the
hose[2].
5. Unscrew the nut from the shut-off valve[]
to drain residual spray material (Fig.N).
6. Unscrew the handle[1] of the shut-off
valve[].
7. Take out the small filter[] (Fig.O).
8. Remove the nozzle accessory[].
9. Unscrew the spray tank cover[8] and
remove the basket filter[].
o If any spray solution is left in the spray
tank[3]:
– Pour the spray solution from the spray
tank[3] into a container approved for
chemicals. Do not store chemicals in the
spray tank for a prolonged period.
– Use clean water to clean and rinse the
spray tank[3] and accessories. A small
amount of mild household detergent may
be added.
– Use a damp, lint-free cloth to clean the
spray tank[3]. Dry the surface with a
dry cloth.
o The following parts can be detached and
cleaned under running water:
– [9] Stainless steel nozzle pipe
– [] Plastic nozzle pipe
– [] Nozzle accessories
– [] Basket filter
– [] Small filter
o If the nozzle accessories[] or the cone
spray head[] are clogged, clean them by
pushing a needle through them.
o If the basket filter[] and the small filter[]
cannot be cleaned thoroughly under
running water, use a brush to clean.
To Next Page
Loading...
Need help?
General