Parkside Performance PSBSAP 20-Li B3 User Manual

PSBSAP 20-Li B3
GB
│
IE
│
7 ■
Safety guidelines for battery
chargers
■ This tool may be used by children
aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowl-
edge, provided that they are
under supervision or have been
told how to use the tool safely
and are aware of the potential
risks. Do not allow children to
use the tool as a toy. Cleaning
and user maintenance tasks may
not be carried out by children
unless they are supervised.
■ To avoid potential risks, dam-
aged mains cables should be re-
placed by the manufacturer, their
customer service department or
a similarly qualified person.
The charger is suitable for indoor use
only.
WARNING!
■ To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP20A1/PAP20A2/
PAP20A3/PAP20B1/PAP20B3/
PAPS204A1/PAPS208A1.
♦ A current list of battery compatibility can be
found at www.Lidl.de/Akku.
Before use
Charging the battery pack
(seefig.A)
CAUTION!
► Always unplug the tool before you remove
the battery pack from or connect the battery
pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Connect the battery packe to the high-speed
charger t (see fig. A).
♦ Insert the power plug into the socket. The green
charge control LEDo lights up briefly, then the
red charge control LEDi lights up.
♦ The green charge control LED o indicates
that the charging process is complete and the
battery packe is ready for use.
ATTENTION!
♦ If the red charge control LEDi flashes,
this means that the battery packe has
overheated and cannot be charged.
♦ If the red and green charge control LEDsi/
o both flash, this means that the battery
packe is defective.
♦ Push the battery packe back into the tool.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.

Parkside Performance PSBSAP 20-Li B3 Specifications

General

Battery Voltage	20 V
Max. torque	180 Nm
Impact rate	0 - 4500 bpm
No-load speed	0 - 2900 rpm
Battery Type	Li-Ion
Max Torque	180 Nm
Chuck	1/4 inch
Chuck Type	1/4 inch