51GB/IE
The charging control LEDs (green
[] and
red
[]) indicate the status of the charger []
and the battery pack
[5]:
LED Status
Red LED lights up Battery pack
charges
Green LED lights up Battery pack fully
charged
Green and red LED
flashing
Battery pack
defective
Red LED flashing Battery pack too
cold or too warm
Green LED lights up
(without battery pack) Charger ready
Insert the battery pack
[5] into the
charger
[].
Connect the power cord with power plug
[]
of the charger
[] to the socket.
When the battery pack
[5] is fully
charged: Remove the battery pack from the
charger
[]. Then disconnect the power cord
with power plug
[] of the charger from the
socket.
Attaching/removing the
auxiliary handle
(Fig. E)
NOTE
u The product may only be operated with the
auxiliary handle
[6] fitted.
Screw the auxiliary handle
[6], depending on
the type of work, to the left (a), right (b) or on
the top (c) of the product using the auxiliary
handle threads
[2].
Adjusting the guard for
grinding
(Fig. F)
m
WARNING!
Before adjusting the guard for
grinding
[]: Switch the product off.
Remove the battery pack
[5] from
the product to prevent the product
from starting unintentionally. Let the
product cool down before making any
adjustments!
m
CAUTION! RISK OF INJURY!
Wear protective gloves. Be careful
when handling the guard for
grinding
[] as there is a pinching
hazard between the guard and the
disc.
NOTE
u The product must only be operated with the
guard mounted.
Adjust the guard for grinding
[] such that
any sparks or detached parts cannot hit either
the user or any bystanders.
The guard for grinding
[] must also be
positioned such that the sparks cannot ignite
combustible parts, including those in the
surroundings.
Turn the guard for grinding
[] to the required
position. With every rotation of 30°, you can
feel and hear the guard for grinding snapping
into place. Only use the product when the
guard for grinding is locked.
To Next Page
Loading...
Need help?
General
