How to fix a Parkside 103318 when the engine does not start?
If your Parkside Inverter's engine won't start, the automatic oil cut-out may not have responded. Check the oil level and top up the engine oil if needed. Another potential cause is a fouled spark plug, which you should clean or replace, ensuring an electrode spacing of 0.6 mm. Finally, make sure you have enough fuel and that the petrol cock is functioning correctly.
What to do if my Parkside 103318 generator has too little or no voltage?
If your Parkside Inverter generator has too little or no voltage, the overcurrent circuit-breaker might have triggered. Try actuating the circuit-breaker and reducing the number of connected devices. Another possible reason is a dirty air filter; in this case, clean or replace it. If these steps don't resolve the issue, the controller or capacitor may be defective.
What to do if my Parkside Portable Generator engine does not start?
If your Parkside Portable Generator's engine won't start, first check the oil level and add more oil if needed. If the oil level is sufficient, the spark plug might be dirty. Try cleaning or replacing it, ensuring the electrode spacing is 0.6 mm. Finally, check if there's enough fuel and have the fuel cock inspected if necessary.
Why won't my Parkside Inverter engine start?
If your Parkside Inverter's engine won't start, it could be due to several reasons. First, the automatic oil cut-out might not have responded; in this case, check the oil level and top up the engine oil if needed. Another possibility is a fouled spark plug, which you can resolve by cleaning or replacing the spark plug, ensuring an electrode spacing of 0.6 mm. Lastly, check if there's enough fuel and refuel if necessary, or have the petrol cock checked.
What to do if my Parkside 103318 has no voltage?
If your Parkside Inverter has too little or no voltage, it could be due to a defective controller or capacitor - contact your dealer. Also, check if the overcurrent circuit-breaker has triggered. If so, actuate the circuit-breaker and reduce the number of consumers. Finally, make sure the air filter isn't dirty; clean or replace it if needed.
General| Model Number | 103318 |
|---|---|
| Input voltage | 12V DC |
| Output voltage | 230V AC |
| Output frequency | 50Hz |
| Continuous power | 300W |
| Peak power | 600W |
| Cooling | Fan |
| Weight | 1.1 kg |
| Protection | Overload, Short circuit |
To Next Page
