Parkside 307044 - Trouble Shooting

26
GB NIIE CY
Trouble shooting
Problem Possible cause Fault correction
Device does not start
Chain brake locked into
place.
Check chain brake.
Possibly release chain brake
Mains voltage defective
House protection fuse
activated
Check plug socket, cable, line
and plug, where appropriate,
repair by electrical specialist.
Check house protection fuse,
see note
Defective On/Off
switch (
A
13)
Repair by customer service
Worn carbon brushes Repair by customer service
Defective motor Repair by customer service
Chain does not
rotate
Chain brake blocks saw
chain (
A
5)
Check chain brake.
Possibly release chain brake
Inferior cutting
performance
Incorrectly mounted saw
chain (
A
5)
Mount saw chain correctly
Saw chain (
A
5) blunt
Sharpen cutting teeth or place
on new chain
 Check chain tension
Saw runs with

comes off
 Check chain tension
Chain becomes hot,
smoke development
during sawing,
discoloration of the
rail
Too little chain oil
Check oil level and, where

check oil automatic system and,
where appropriate, clean oil

customer service