Introduction
5
Engraving point
6
Engraving point holder
7
Engraving stencils
Included items
1 Power engraving tool PGG 15 A1
2 Engraving stencils
1 Operating instructions
Technical details
Rated voltage: 230 V∼ 50 Hz
Mode of operation: intermittent operation: S3 20 %
Note: A duty cycle (in %) defines explicitly the maximum continuous
duration of use and the subsequent rest period. In this case the tool
requires a cooling phase of eight minutes after an operating period of
two minutes, for example.
Rated current: 0.15 A
Stroke rate: 6000 min
-1
Noise and vibration data:
Measured values for noise are determined in accordance with
EN 60745. The A-weighted noise level of the electrical power tool
are typically:
Sound pressure level: 74.4 dB(A)
Sound power level: 85.4 dB(A)
Uncertainty K: 3 dB
To Next Page
Loading...
