Parkside PAS 4 B4 - Changing Bits;Screw Driver Bits (See Fig. B)

PAS 4 B4
GB
│
IE
│
NI
│
CY│ 15 ■
Starting charging:
♦ Connect the micro USB plug of the charging cable
9b
to the
charging socket .
♦ Connect the USB plug of the charging cable
9a
to the charger
.
♦ Connect the charger
to a 100 - 240 V ∼ 50 - 60 Hz power
source.
The battery is fully charged when the battery level display
changes
from red to green.
Stopping charging:
♦ Disconnect the charger
from the mains power supply.
♦ Disconnect the micro USB plug of the charging cable
9b
from
the charging socket .
Changing bits/screw driver bits (see fig. B)
Inserting:
♦ Insert a bit
into the tool holder .
Removal:
♦ Pull the bit
out of the tool holder .