PBK 4 A2
■ 16
│
GB
│
IE
│
NI
Maintenance intervals
Pole pruner
The figures given here are based on normal operating conditions. In difficult
conditions, e.g. heavy dust formation and longer daily working hours, the
specified intervals must be shortened accordingly.
Tool part Action Before
starting
work
Weekly In the
event
of an
error
In the
event
of dam-
age
As re-
quired
Chain
lubrica-
tion
Check
X
Saw
chain
Check
and note
sharpness
X
Check
chain
tension
X
Sharpen X
Guide
rail
Check
(wear,
damage)
X
Clean and
turn
XX
Deburr X
Replace X X
Chain
sprocket
Check X
Replace
X
Hedge trimmer
The figures given here are based on normal operating conditions. In diffi-
cult conditions, e.g. heavy dust formation and longer daily working hours,
the specified intervals must be shortened accordingly.
Tool part Action Before starting
work
After finishing
work
As
required
Cutting
blade
Visual inspection X
Cleaning X X
Ordering replacement parts
Ordering spare parts
The following information should be provided when ordering spare parts:
■ Type of tool
■ Item number of the tool
■ Device ID number
Current prices and information are available at
www.kompernass.com
NOTE
■
Replacement parts that are not listed (e.g. strimmer, cutting filament)
can be ordered via our service hotline.
Disposal
The packaging for this product is made from environmentally
friendly material and can be disposed of at your local
recycling plant. The device and its accessories are made from
various materials, such as metal and plastic.
Your local community or municipal authorities can provide information on
how to dispose of the worn-out tool.
Dispose of the packaging in an environmen tally friendly manner.
Note the labelling on the packaging and separate the pack-
aging material components for disposal if necessary. The
packaging material is labelled with abbreviations (a) and
numbers (b) with the following meanings: 1–7: plastics, 20–22: paper
and cardboard, 80–98: composites.
Your local community or municipal authorities can provide
information on how to dispose of the worn-out product.
Environmental protection
■ Carefully empty the petrol and oil tank and dispose of your tool at a
recycling plant. The used plastic and metal parts can be separated and
recycled.
■ Dispose of waste oil and petrol at a waste collection centre and do not
dump them into the sewerage or drainage system.
■ Dispose of contaminated maintenance material and consumables at
a collection point provided for this purpose.
To Next Page
Loading...
Need help?
General
