Parkside PBRM 39 C2 User Manual (English)

Questions and Answers:

K
Kevin KnappAug 3, 2025
Why won't my Parkside PBRM 39 C2 Lawn Mower engine start?
- C
  Caitlin BrownAug 3, 2025
  Your Parkside Lawn Mower engine may not start due to several reasons: the engine brake lever might not be pressed, so ensure you press it. The throttle could be in the wrong position, so check its setting. The spark plug might be defective and require replacement. The fuel tank could be empty, requiring a refill. The fuel could be contaminated, in which case you should empty the tank and refill it with clean fuel. In the event that none of these solutions work, the engine may be defective, and you should contact authorised customer service.
W
wilsonmariahAug 7, 2025
What to do if the discharge of grass clippings is unclean for Parkside PBRM 39 C2 Lawn Mower?
- C
  Christopher BonillaAug 7, 2025
  If your Parkside Lawn Mower isn't discharging grass cleanly, it could be due to a few reasons. The cutting height might be too low, so adjust it. The blade could be worn, in which case you should replace it. The grass collection basket might be blocked, so empty it or remove any blockages.
E
Erica PatelAug 11, 2025
Why is my Parkside Lawn Mower leaving yellow patches and uneven cuts?
- W
  wlopezAug 11, 2025
  If your Parkside Lawn Mower is causing the lawn to turn yellow or resulting in uneven mowing, the blade may be blunt and needs sharpening. Also, check if the cutting height is set too low and adjust it to the correct height.
T
Thomas JohnsonAug 16, 2025
What to do if Parkside PBRM 39 C2 Lawn Mower runs unsteadily and vibrates heavily?
- T
  Tommy AyersAug 16, 2025
  If your Parkside Lawn Mower runs unsteadily and vibrates heavily, check the screws and blade fasteners to ensure they are not loose. If the blade is unbalanced, replace it.
S
Sandra GreenAug 19, 2025
What to do if Parkside Lawn Mower discharge of grass clippings is unclean?
- S
  Stephen HallAug 20, 2025
  If the discharge of grass clippings from your Parkside Lawn Mower is unclean, it might be because the cutting height is too low. Try adjusting the cutting height. Another reason could be a worn blade, which should be replaced. Also, check if the grass collection basket is blocked; if so, empty it or remove the blockage.
J
Jason LambAug 25, 2025
What to do if my Parkside Lawn Mower engine does not run?
- I
  itaylorAug 25, 2025
  If your Parkside Lawn Mower engine won't start, make sure the engine brake lever is pressed. Check the throttle position and replace the spark plug if it's defective. Refill the fuel tank if empty, or empty and refill with clean fuel if contaminated. In cold environments, press the fuel pump primer. If none of these steps work, the engine may be defective, and you should contact authorised customer service.
J
Jeff TaylorAug 29, 2025
Why does my Parkside PBRM 39 C2 Lawn Mower engine run unsteadily?
- M
  Michael WalkerAug 29, 2025
  If your Parkside Lawn Mower is running unsteadily, the air filter or spark plug may be dirty. Try cleaning the air filter and spark plug.