PHP 500 E3
■ 22
│
GB
│
MT
♦ Apply the glue in spots. For flexible materials,
such as textiles, apply the glue in zigzag lines.
♦ Press the two workpieces to be bonded together
immediately after applying the glue and hold
for about 30 seconds. The glued bond is ready
after about 5 minutes.
♦ During breaks in work, put the glue gun down
on the plastic stand
or replace it in the
charger .
♦ Remove any glue residue after it has cooled
down with a sharp knife. Bonded joints can be
released by heating.
Switching the appliance off:
♦ Unplug the appliance from the mains socket.
Maintenance and cleaning
WARNING! ALWAYS REMOVE THE
POWER PLUG FROM THE POWER
SOCKET BEFORE CLEANING THE
APPLIANCE.
■ The glue gun is maintenance free.
■ Keep the appliance clean and dry at all times.
■ Never permit liquids to enter inside the
appliance. Use a cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
Disposal
The packaging is made from environmen-
tally friendly material and can be
disposed of at your local recycling plant.
Do not dispose of electrical ap-
pliances with normal domestic waste!
As required by European Guideline 2012/19/EU,
worn-out electrical appliances must be collected
separately and fed into an environmentally compa-
tible recycling process.
Your local community or municipal authorities can
provide information on how to dispose of the worn-
out appliance.
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary.
The packaging material is labelled
with abbreviations (a) and numbers
(b) with the following meanings:
1–7: Plastics,
20–22: Paper and cardboard,
80–98: Composites
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out
product.
To Next Page
Loading...
Need help?
General
