Parkside PLS 48 C1 Translation Of The Original Instructions

PLS 48 C1
GB
│
9 ■
Soldering
Vapours can lead to headaches and fatigue if inhaled.
■ The soldering iron has a rated power output of 48 watts and is
ideal for electronic solders.
■ Its design makes it especially suitable for difficult-to-access and
fine soldering work.
♦ Clean the soldering tip
on the moist soldering sponge .
♦ After cleaning, the soldering tip must be tinned. Tin the hot
soldering iron tip by melting the solder
.
♦ Guide the soldering tip to the solder joint and heat it.
♦ Place the solder (with flux) between the solder joint and soldering
tip to melt it.
♦ Keep feeding in solder until the entire solder joint is covered.
♦ Then withdraw the soldering tip immediately to prevent over-
heating the molten solder.
♦ Allow the solder to harden and avoid vibrations.
NOTE
► The flux is either included in the solder or applied separately.
When buying the solder, ask about its use and the appropriate
flux.

Parkside PLS 48 C1 Specifications

General

Brand	Parkside
Model	PLS 48 C1
Category	Soldering Gun
Language	English