How to fix a Parkside Power Tool that does not start?
If your Parkside Power Tool doesn't start, first check the socket, power cable, line, and power plug. If necessary, have a qualified electrician perform repairs. Also, verify the main circuit breaker. It could also be due to a broken on/off switch, in which case you should seek repair by Customer Care. Finally, the motor itself might be faulty.
What to do if my Parkside Power Tool's engine is slower and stops?
If the engine of your Parkside Power Tool is slower and stops, it might be overloaded by the workpiece. Reduce the pressure. Also, consider increasing the rotation speed or using a more suitable workpiece.
What to do if my Parkside Wood Router does not start?
If the Parkside Wood Router isn't starting, first, check the socket, power cable, line, and power plug. If necessary, have a qualified electrician perform repairs. Also, check the main circuit breaker. If these aren't the cause, the on/off switch may be broken and needs repair by Customer Care, or the motor may be faulty.
Why does the milled work piece have burn marks with my Parkside Wood Router?
If the milled work piece has burn marks when using the Parkside Wood Router, try increasing the rotation speed. Also, the cutter may be unsuitable or blunt, so try changing it. If the cutting depth is set too large, use the step stop to mill in multiple steps.
What to do if fringes of the milled part tear off when using Parkside POF 1200 C2?
If the fringes of the milled part tear off, or there are grooves and uneven parts in the milling when using the Parkside Wood Router, the cutter is likely worn out, dull, or the cutter blades are damaged. Try changing the cutter.
Why is my Parkside Wood Router engine slower and stops?
If the engine of your Parkside Wood Router is slower and stops, it might be overloaded by the workpiece. Reduce the pressure. You may also need to increase the rotation speed or the workpiece may be unsuitable.
How to fix dust not being sucked off on Parkside Wood Router?
If dust is not being sucked off when using the Parkside Wood Router, ensure the vacuum is switched on before milling. Also, check if the suction hose or suction adapter is clogged and remove any blockages.
What to do if the milling is not straight with Parkside POF 1200 C2 Wood Router?
If the milling is not straight with the Parkside Wood Router, the guide bars of the parallel stop might not be mounted firmly. Retighten the screws of the guide bars if necessary.
Why does the milled workpiece have burn marks when using my Parkside Power Tool?
If the milled workpiece has burn marks, it could be due to several reasons. You may need to increase the rotation speed. The cutter might be unsuitable or blunt, in which case you should change it. Also, the cutting depth may be set too large; try using the step stop to mill in multiple steps.
Why do the fringes of the milled part tear off when using my Parkside Power Tool?
If the fringes of the milled part tear off and there are grooves and uneven parts in the milling when using your Parkside Power Tool, the cutter is likely worn out, dull, or the cutter blades are damaged. Try changing the cutter.
General| Brand | Parkside |
|---|---|
| Model | POF 1200 C2 |
| Category | Wood Router |
| Language | English |
Interpretation of warning symbols used within the instruction manual.
Explanation of safety symbols and indicators present on the tool itself.
Step-by-step instructions for safely installing and replacing cutting tools.
Method for achieving precise cutting depths in multiple passes for better control.
Procedures for safely powering the machine on and off.
To Next Page
