Why is visibility poor with my Parkside PSHL 2 D1?
Poor visibility with Parkside Motorcycle Accessories can occur if the viewing pane or rear lens is dirty; clean them. Also, remove the protective film from the rear lens if it hasn't been removed. Insufficient ambient light or an incorrect darkening level can also cause this issue. Ensure sufficient light in your workspace and re-set the darkening level.
Why does the filter not become dark steadily or flicker on Parkside PSHL 2 D1?
If the filter in your Parkside Motorcycle Accessories isn't darkening steadily or flickers, it could be due to a dirty or defective viewing pane; clean or replace it. Another cause might be an unclear arc sensor, so clean its surface. If the welding current is too low, set the sensitivity to the maximum level.
Why is the reaction slowed down on Parkside PSHL 2 D1?
If the reaction time of your Parkside Motorcycle Accessories is slowed down, it might be due to the ambient temperature being too low or too high; only use the welding helmet at temperatures between -5°C and +55°C. Alternatively, the sensitivity might be too low; adjust it to a higher level.
How to stop my Parkside Motorcycle Accessories welding helmet from slipping?
If your Parkside Motorcycle Accessories welding helmet slips, the headband might be incorrectly adjusted. Readjust the headband and make it tighter for a secure fit.
Why is visibility poor when using Parkside Welding Accessories?
Poor visibility with Parkside Welding Accessories can occur for several reasons: * The viewing pane or rear lens might be dirty; clean them. * The protective film on the rear lens might not have been removed; remove it. * There might not be enough ambient light; increase the light in your workspace. * The wrong darkening level might be set; readjust the darkening level.
What to do if the Parkside Welding Accessories filter flickers or doesn't darken steadily?
If the filter on your Parkside Welding Accessories isn't darkening steadily or is flickering, it could be due to: * A dirty or defective viewing pane: Clean or replace the viewing pane. * An unclear arc sensor: Clean the surface of the arc sensor. * Welding current that is too low: Set the sensitivity to the maximum level.
Why is the reaction slowed down when using Parkside Welding Accessories?
A slowed reaction time in your Parkside Welding Accessories can happen because: * The ambient temperature is too low or too high: Only use the welding helmet at temperatures between -5°C and +55°C. * The sensitivity is too low: Adjust the sensitivity to a higher level.
How to fix a slipping Parkside Welding Accessories helmet?
If your Parkside welding helmet is slipping, it's likely that the headband is adjusted incorrectly. Readjust the headband and make it tighter.
Details the specific applications for which the welding helmet is designed.
Lists all the items included in the product packaging.
Details the procedure to test the welding helmet's darkening feature.
Outlines the terms and conditions under which the warranty is valid.
Specifies the duration of the warranty and consumer rights regarding defects.
Details what is covered and not covered by the product's warranty.
General| Brand | Parkside |
|---|---|
| Model | PSHL 2 D1 |
| Category | Motorcycle Accessories |
| Language | English |
To Next Page
