Why is the Parkside Solar panel pumping capacity insufficient?
Insufficient pumping capacity may occur if the housing is clogged with dirt, so you should clean the pump 1 according to the instructions in the “Maintenance and cleaning” chapter. Also, check the attachments 6 – 10 for dirt. If they are dirty, clean them according to the instructions in the “Maintenance and cleaning” chapter.
What to do if Parkside Solar panel pump 1 does not run?
If pump 1 does not run, it may be due to a disconnected solar panel 4. Ensure a proper connection between pump 1 and solar panel 4. Alternatively, the solar panel 4 might not be getting sunlight. Position the solar panel 4 in direct sunlight and remove any dirt if necessary.
What to do if Parkside Solar panel pump 1 does not pump water?
If pump 1 isn't pumping water, the housing might be clogged with dirt. Clean the pump 1 according to the “Maintenance and cleaning” chapter. Another reason could be that the water level is too low. Ensure the pump 1 is completely covered with water.
Why does Parkside PSTS 12 A1 Solar panel pump 1 switch off quickly?
Pump 1 might be switching off quickly due to excessive contaminated water. Clean the pump 1 and consider fitting an additional filter (not included). Also, the water temperature might be too high. Ensure that the water temperature does not exceed 35°C.
General| Brand | Parkside |
|---|---|
| Model | PSTS 12 A1 |
| Category | Solar panel |
| Language | English |
To Next Page