What to do if Parkside PWSAM 20-Li A1 Grinder attachment tool doesn't rotate smoothly?
If the attachment tool of your Parkside Grinder isn't rotating smoothly and you hear unusual noises, it could be due to a loose clamping screw. Tighten the clamping screw. Alternatively, the attachment tool itself may be defective, so try changing the grinding disc.
Why Parkside PWSAM 20-Li A1 Grinder attachment tool does not move?
If your Parkside Grinder's attachment tool isn't moving even though the motor is running, it could be due to a loose clamping screw. Make sure to tighten the clamping screw. It's also possible that the drive is blocked by the workpiece or remnants of the workpiece or attachment tools, so clear any blockages.
Why does my Parkside PWSAM 20-Li A1 engine slow down and stop?
If your Parkside Grinder engine slows down and stops, it might be overloaded by the workpiece. Try reducing the pressure on the attachment tool. Also, the workpiece might be unsuitable.
Why my Parkside PWSAM 20-Li A1 does not start?
If your Parkside Grinder doesn't start, there might be several reasons: * The rechargeable battery might not be inserted. Ensure the battery is properly inserted. * The rechargeable battery might be discharged. Try charging the battery. * The On/Off switch may be broken or the motor may be defective.
Provides key technical data, dimensions, and performance metrics of the device.
Explains the importance and meaning of DANGER, WARNING, and CAUTION messages.
Identifies and explains the safety pictograms found on the tool and its parts.
Guidelines for maintaining a safe workspace and avoiding electrical hazards.
Advice on protective equipment and safe operating practices.
Instructions for proper use, care, and maintenance of the power tool.
Critical safety information for handling rechargeable batteries and chargers.
Essential safety advice for performing grinding and cutting operations.
Detailed safety instructions for grinding and cutting tasks, including accessory use.
Solutions for frequent problems encountered with the angle grinder.
General| Battery Voltage | 20 V |
|---|---|
| Disc Diameter | 125 mm |
| Spindle Lock | Yes |
| Battery Type | Lithium-Ion |
| Spindle Thread | M14 |
| No-load Speed | 8500 rpm |
To Next Page