What to do if trim changes when flight mode is switched on PARKZONE VisionAire AS3X?
If you observe a trim change when switching flight modes on your PARKZONE Toy, it's likely because the trim isn't at neutral. If you've adjusted the trim more than 8 clicks, adjust the clevis to remove trim. Also, ensure that the Sub-Trim is at neutral. No Sub-Trim is allowed, so adjust the servo arm or the clevis.
How to fix incorrect response to AS3X Control Direction Test on PARKZONE VisionAire AS3X?
If your PARKZONE Toy shows an incorrect response to the AS3X Control Direction Test, it's likely due to incorrect direction settings in the receiver. This can cause a crash. DO NOT fly. Correct the direction settings (refer to the receiver manual), then fly.
Why is my PARKZONE VisionAire AS3X oscillating?
If your PARKZONE Toy experiences oscillation, it could be due to several factors. You might be flying over the recommended airspeed, so try reducing your speed. Check for any damage to the propeller or spinner and replace them if necessary. An imbalanced propeller can also cause this issue, so balance it. Adjust the gain to match current flight conditions like wind, updrafts, elevation, humidity, and temperature. Motor vibration can also lead to oscillation; replace parts or correctly align and tighten all fasteners. Ensure the receiver is securely aligned in the fuselage. Also, tighten any loose aircraft controls, including the servo, arm, linkage, horn, and control surface. Worn parts, especially the propeller, pivot points, or servo, can cause oscillation, so adjust the gain or replace ...
Guidelines for safe operation and age restrictions for the model aircraft.
Critical safety instructions and precautions for handling Li-Po batteries.
Welcome and overview of the 3D flight capabilities and AS3X system.
List of all items included in the aircraft package.
Technical details, dimensions, and weight of the VisionAire model.
Detailed procedures for safely charging the Li-Po flight battery.
Explanation of the LVC function protecting the battery from over-discharge.
Step-by-step process to link the transmitter to the aircraft receiver.
Instructions on how to properly install the flight battery into the aircraft.
Overview of the AS3X flight stabilization technology.
Procedure for powering up the Electronic Speed Controller and receiver.
Instructions for attaching the aircraft's landing gear.
Steps for attaching the horizontal tail assembly to the fuselage.
Adjusting control surfaces to their neutral positions for proper flight.
Optimizing linkage positions for desired flight response.
Attaching the wing fences for enhanced stability and performance.
Securing the main wings to the aircraft fuselage.
General transmitter settings for different models and dual rates.
Adjusting flight response characteristics like sensitivity and throw.
Ensuring aircraft control surfaces move correctly in response to transmitter commands.
Verifying the AS3X system's response to aircraft movements.
Determining the correct balance point for optimal flight stability.
Advice on radio checks, takeoff, flying, and landing procedures.
A checklist for ensuring readiness before the aircraft's initial flight.
Procedures for post-flight care, battery storage, and cleaning.
Guidance on repairing minor damage to the aircraft's airframe.
Techniques and advice for executing advanced 3D aerobatic maneuvers.
Instructions for disassembling and assembling the motor and propeller.
Adherence to national safety standards for model aircraft pilots.
Solutions for oscillation and other AS3X system related problems.
Troubleshooting common issues like control loss or motor problems.
Details on product warranty coverage and limitations.
Procedures for requesting product service or repair from Horizon Hobby.
How to contact Horizon Hobby for assistance and inquiries.
Regulatory compliance information and WEEE disposal instructions.
Catalog of available spare parts for the aircraft.
Where to obtain replacement parts from Horizon Hobby.
List of optional accessories to enhance the aircraft's capabilities.
General| Speed Control | 30A Brushless ESC |
|---|---|
| Material | Z-Foam |
| AS3X Technology | Yes |
| Experience Level | Intermediate |
| Motor | 480 Brushless Outrunner |
| Battery | 3S 11.1V 2200mAh LiPo |
| Radio System | 6+ channel DSM2/DSMX (required) |
| Servos | 4 Sub-Micro Servos |
To Next Page