9
How To Use Your Oven
This multi-function oven combines the advantages of traditional convection ovens with a
modern fan assisted oven in a single appliance. It is an extremely versatile appliance that
allows you to choose easily and safely between different cooking modes. The various
cooking modes are selected by means of the cooking mode selection knob, located on
the control panel.
It is important to remember that this oven may perform differently to the way your
previous appliance worked. To obtain the best cooking results please experiment with
temperature, rack height and cooking times. As a helpful guide please refer to the
“Cooking Mode Table”.
To operate this oven:
• Ensure that manual mode is selected (Page 16).
• Turn the cooking mode selection knob to the desired cooking mode (explanation of
cooking modes is on pages 14 to 15).
• Turn the temperature selection knob to the desired temperature (please refer to the
helpful cooking guide.).
• If grilling turn the temperture selection knob to “MAX”
The first time you use your appliance, we recommend that you set the temperature to
“MAX”, set the cooking mode selection knob to a cooking mode and leave the oven
operating (empty) for approx ½ an hour. Then turn off the appliance and allow to cool.
Any odours that may be detected during this initial use is due to the evaporation of
substances used to protect the appliance during manufacture and storage.
NOTE: Place the baking tray provide on the bottom shelf position to prevent any
spillages from dripping onto the bottom of the oven. Never place anything (including
foil and oven trays) directly onto the bottom of this oven when it is in operation as
this could damage the enamel. Only place your cookware (dishes, trays, aluminium
foil etc) on the oven shelves provided with this appliance
Fit the trays and shelves
between the two closest
wires as shown right
To remove the side support
racks, push down on the wire
below the locking pin and pull
away from the oven wall until
you can release the bottom of
the support from the holes in
the oven wall. To replace
reverse this procedure.
To Next Page
