CLIO 3
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the
authorisation of Parrot SA. Pictures for information only.
Affix the bracket provided after
cleaning the sun visor support.
Then run the cable under the
headliner .
Using a guide, feed the cable
inside the sun visor support
towards the windscreen.
Reclose the sun visor support
panel . (BE CAREFUL not to cut
the cable.)
Run the cable along the driver's side
windscreen support while replacing the
door seal.
1
3
2
4
5 6
Pass the cable into the
dashboard on the left side.
Run the cable under the steering
wheel panel towards the radio
housing, attaching with wire ties.
!
To Next Page
Loading...
Need help?
General
