To Next PageTo Next Page
Need help?Do you have a question about the Partner P12597H and is the answer not in the manual?
General| Steering | Manual |
|---|---|
| Engine Type | Diesel |
| Clutch | Single Dry Plate |
| Brakes | Mechanical |
| Turning Radius | 2.5 meters |
Instructions for mounting the steering wheel and its components.
Steps for installing and adjusting the tractor seat for operator comfort.
Procedure for installing and connecting the tractor's battery.
Guide for installing the mulcher plate for grass mulching functionality.
Identifies and explains the location and function of the tractor's controls.
Instructions for safely filling the fuel tank with the correct type of petrol.
How to check and maintain the engine oil level using the dipstick.
Guidelines for checking and maintaining correct tire inflation pressure.
Steps for safely starting the tractor's engine.
How to use the choke control for starting a cold engine.
Adjusting the throttle for a warm engine during starting.
Detailed steps for turning the ignition key to start the engine.
Special procedure for warming up the hydro transmission in cold conditions.
Procedure for removing air from the transmission system.
How to operate the tractor, including lowering the cutting unit and choosing speed.
Explanation of the Reverse Operation System and its safe use.
Advice on how to achieve the best cutting results and maintain the lawn.
Safety precautions and techniques for driving the tractor on slopes.
Methods for cutting grass near obstacles and proper turning.
Steps for safely shutting down the tractor's engine.
Instructions for opening, closing, and disconnecting the engine hood.
Procedures for cleaning the tractor, avoiding high-pressure water.
Step-by-step guide for draining and refilling the engine oil.
Information on the safety systems related to operator presence and reverse operation.
Guidance on blade sharpening, removal, installation, and balancing.
Steps to remove the cutting unit from the tractor for maintenance.
Steps to reinstall the cutting unit onto the tractor.
Instructions for removing and installing the drive belt for the cutting unit.
How to adjust the cutting unit for proper height and levelness.
Procedure for adjusting the cutting unit's side-to-side levelness.
How to adjust the motion control lever for proper neutral positioning.
Procedure to check the tractor's brake system for proper function.
Maintaining the fan and cooling fins of the transmission for proper operation.
Information regarding transaxle fluid and maintenance requirements.
Steps to prepare the machine for storage, including cleaning and fuel management.
